|
|
Post by 3DMS on Oct 10, 2017 16:32:42 GMT
|
|
|
|
Post by brugiova on May 5, 2018 12:57:59 GMT
could I have instructions on how to mount the Kit on board MKS Gen L 1.0?
besides I have the BLTouch (on Servo1)
can I mount the Kit on the Servo2?
in case, I have to change the firmware (I use marlin)?
the present documentation is not very clear, due to my limited knowledge.
thank you
|
|
|
|
Post by 3DMS on May 5, 2018 15:55:59 GMT
The pS_on kit is not connected on the servo pins, it's connected on the ramps on a special pin with open collector (D12)
from the MKS Gen L schematic from here (http://reprap.org/wiki/File:MKS_GEN-PIN.PNG) the D12 pin is not available, so you will have to edit your pins.h file and reroute the signal to another available pin on your Gen L board.
|
|
|
|
Post by brugiova on May 7, 2018 13:12:51 GMT
I'm not that far from success the Gen L card has the VCC port (compare image attached) after pressing the button the machine turns on if I give the command M81 - or "Shut Down" from LCD - the writing "Off" appears on the display, but the machine stays on similarly with M80 (appears ON) How can I solve? I attach wiring image and firmware changes.   |
|
|
|
Post by 3DMS on May 7, 2018 13:57:02 GMT
try to change line 61 to 7, output D11 might already be initialized for other purposes (here it seems it might already be used by servo_0)
|
|
|
|
Post by brugiova on May 7, 2018 15:25:48 GMT
it still does not work. even worse. if release the button goes out.
I also tried D4, D5 and D6 but only in D11 stays on
I buy a RAMPS
|
|
|
|
Post by 3DMS on May 7, 2018 15:45:45 GMT
try to use 1 pin from AUX 1 instead
|
|
