|
Post by 3DMS on Nov 7, 2015 20:44:35 GMT
If you are using Esun grey PLA, here is some settings that is working fine. - Hot end temperature: 205-210°C
- Heatbed temperature: 60°C
- Use some air spray on the first print, just a thin film of spray will do.
- Layer height: 15mm
- Shell thickness: 2 pass( double the diameter of your hotend), 1.0 if your nozzle is 0.5mm
- Retraction / Speed: 45 to 60 mm/s
- Retraction / Distance: 1.8 for AllInOne 0.5mm nozzle
- Retraction / Distance: 3.0 for E3D 0.8mm nozzle
- Travel speed: 100mm/s for Scalar M
- Travel speed: 90mm/s for Scalar XL
- Bottom Speed layer: 25mm/s
- Infill speed: 50mm/s (it depends on the nozzle size, the bigger, the slower)
- Top/Bottom speed: 40mm/s
- Outter shell speed: 40mm/s
- Inner shell speed: 45mm/s
- Minimal layer time: between 6 to 10 sec
- Enable cooling fan: checked
- If you have a AllInOn hot end, fan blowing at 50% is a good starting point.
- If you have a E3D hot end, fan blowing at 40% is a good starting point.
|
|